Thought It was about time I update the build thread...
So heres how motor sits. It sat a little sideways because of mounts, But I cut out a rectangular peice of metal and drilled a hole in it to use it as a spacer for the mounts, so now the motor isnt as sideways.. Just a temporary fix until I have time and money to have real mounts made..
My Super JDM fix for some scratches in the door panel.. lol
Had a 1 peice driveshaft made, Heres how it came out. I'm actually really happy the way it came out!.
The ebay intercooler mount setup.. yaay. You get what you pay for. But this setup is actually pretty stirdy, so it doesn't bother me too much!.
Cutting ghetto holes for IC piping. dont laugh, it works!
Got the radiator hooked up.
Lower IC pipes are done! I just bought a Sr20 intercooler setup, just cut a few of the upper pipes and the passenger side worked about perfectly.
---------- Post added at 02:02 PM ---------- Previous post was at 01:54 PM ----------
And after a day of tightening everything down, bleeding clutch, and brakes. got the wheels on and dropped her on the ground for the first time in 3 months!
And up it goes! Onto the flatbed and headed to Portland Speed Industries to get wired up!
andd its done, kinda.
http://www.youtube.com/watch?v=Lh2wO7DJfd8
I drove it around for about a month or two but just the other day, something happened and the upper radiator hose rubbed on power steering pump and cut it.
so now its time to properly fix it.
I need to get rid of the traction control on the throttle body, and that is where I am stumped right now..
I don't know how I am going to go about cutting traction control off.. Because of all these vac lines(or whatever they are) are in the way.
Left Side
Bottom
Right side
Top
