Remote Oil thermostat

[tte]

I installed a oil relocation kit on the car.
I just received my oil cooler and remote oil thermostat.

How do I route the hoses to the thermostat and oil cooler?

The thermostat has 4 threaded holes labelled E1,E2,C1,C2.
This is the thermostat I just bought.

My oil relocation kit had has In/Out on both adaptors...one on the block and the remote one housing the oil filter.

http://store.summitracing.com/partdetail.asp?autofilter=1&part=PRM-1070&N=115&autoview=sku

Cheers,
Roy

 

[supraguru05]

the out of the block goes to the in on the filter the out of the filter goes to the thermostat e1 the e2 on the thermostat goes to the in on the block. the c1 goes into the cooler and the c2 does as well

verify this with someone to be sure but thats the way permacool labels their thermostats i belive

 

[jdub]

^^^ This is correct. Look in the thermostat and you will see the valve...it will be partially open allowing a 10% flow to the cooler at all times. This is the side you connect to the "out" from the filter head...it should be E1 with C1 on the opposite side of the same hole.

I assume you're using a NA filter stud for the block adapter.

I see you went the low cost route for the thermostat...there's a reason the PermaCool thermostats are cheaper than the Mocal I recommended in the other thread
Hope you have good luck with it.