really need advice

[DSGsupra89]

Alright I did an t70 upgrade with an 3in exhaust. Everything run fine and I luv it. I notice that my oil pressure was getting low and I hoping I didn't blow my turbo seals. But I found out that oil was coming out of my dipstick from boosting. I got it home and oil is still coming out. When I think things can't get any worse I here knocking going I hoping that I don't have a rod nock. I let a few people check it out and they say it sounds like me lifters are nocking because rod nock can be heard like 2 nocks at the same time. Well I need advice on what to do on the oil dipstick problem and the lifter problem thanks

Dee

 

[black89t]

check you valve clearance if its out of spec correct it with new shims.

with the oil problem. check the level. i know it sounds stupid, but i like to start simple. the lower part lightly pressed into the block and might be leaking. also the upper part just seals with a o-ring so that could be your problem, but the level has to be pretty high for that to even be a option. unless your saying it comes out the top of the dipstick. if thats the case you have some SERIOUS blowby/crank pressure.


how do you have the "pcv" set up.



edit: LOL. i need to edit better.

 

[IwantMKIII]

get a new o-ring seal for your dipstick


whats the specs on your engine?

 

[DSGsupra89]

check you valve clearance if its out of spec correct it with new shims.

with the oil problem. check the level. i know it sounds stupid, but i like to start simple. the lower part lightly pressed into the block and might be leaking. also the upper part just seals with a o-ring so that could be your problem, but the level has to be pretty high for that to even be a option. unless your saying it comes out the top of the dipstick. if thats the case you have some SERIOUS blowby/crank pressure.


how do you have the "pcv" set up.

Alright I just found out that my dipstick is an 7mge dipstick and I seen alittle oil coming out while the car is idling. This is a newbe question but how do I do shim work on my car if the clearance is not right can some show me a thread if there one. Also is I do have a serious blowby how do I fix that need to get my car back asap thanks. Anothe PCV were is that another newbe question.

Dee

 

[suprahooked]

These motors dont have lifters... Over head cams

 

[ForcedTorque]

This thread ain't got no english

 

[DSGsupra89]

These motors dont have lifters... Over head cams

Well valve if there are taping I really hoping its not a Rod nock. If I do have it Im going start looking for a 1j or see to rebuild the bottom end need advice what should I do what good upgrades should I do for the bottom end thanks.