I got a new clutch kit and bought a used fork from someone here. However I can't see how the fork matches up with the bearing. It doesn't match either side. Am I missing a part?
R154 clutch fork and throwout bearing.
- Thread starter Count Knobula
- Start date
Dude i had the SSSAAAMMMEEE problem cause id idnt kno WTH i was doing but it was EZ when i looked over the TSRM
Put the HUB on the PP. Using the appropriate snap rings to hold it in place. Take the fork OFF of the transmission and keep it off untill the transmission is on the motor.
Put the clutch disk and pressure plate on the transmission. Bolt it up then bolt down the pressure plate. Once thats done slide the fork into position and then thats it.
^ I hope that process is correct, im just going off of memory but check out the TSRM
Put the HUB on the PP. Using the appropriate snap rings to hold it in place. Take the fork OFF of the transmission and keep it off untill the transmission is on the motor.
Put the clutch disk and pressure plate on the transmission. Bolt it up then bolt down the pressure plate. Once thats done slide the fork into position and then thats it.
^ I hope that process is correct, im just going off of memory but check out the TSRM
BTW that snap ring is a BITCH....but like the guy^^^ said, leave the fork off until you bolt the tranny to the block, it is fairly easy to get it on...