Questions about paint and some other stuff, mostly just chat+q&a

[gotsomegetsome]

hey so i am doing a paint job on my stoopra and its comin along nicely
HOWEVER does anyone know what causes the clear coat to make little white pieces ... hard to explain but anyways...



oh and has anyone ever done a paint job and then had to re-bend the trim to get it straight. not a whole lot just enough to where its not perfectly strait anymore. I need to do that and i wanted to see if anyone has does it before



lastly any insight to getting the vibration down a little after removing all the interior down to bare body? perhaps urethane? i found some stuff on mcmastercarr that seems good for noice dampening and heat shielding, but im really only concerned about the dampening. i just dont wanna have to buy the expensive dynamat that they use on overhauled and stuff
I WISH THO!!!!

thanks

 

[gotsomegetsome]

aw man

 

[rayall01]

If you used a single stage, you wouldn't have to worry about that.

 

[gotsomegetsome]

ok what a worthless post.

 

[suprarx7nut]

For vibration dampening use dynamat. The new stuff is very effective and lightweight.

 

[gotsomegetsome]

did you not read the op? I dont want to buy dynamat. i was asking about the stuff from mcmastercarr

 

[suprarx7nut]

did you not read the op? I dont want to buy dynamat. i was asking about the stuff from mcmastercarr

Oh. Dammit. I read the post, but skimmed right over that. My bad.

I'm sure there are dynamat knock-offs online, but it may be a total waste.

 

[gotsomegetsome]

thanks though. have you used dynamat? like what can you say about it