Profec optional warning buzzer.

[sabersupra]

Hey guys, I am trying to hook up the optional warning buzzer on my Profec EO1 and having some diffuculty. The online manual does not mention much about it other than it's an option. I hooked up the yellow wire from the Profec to the + of the buzzer and I connected the - of the buzzer to ground. I contacted Greddy and was informed that the yellow wire gives off 12v then in warning mode. Has anyone used this feature that could offer advise? I was also told that I need to adjust the Analog output options, but that did not work.

http://www.greddy.com/img/PHP/products/pdf/796.pdf

Thanks!

 

[Fletch124]

Im assuming if the yellow wire was giving off 12v then you would wire a buzzer to that and the ground to the buzzer as well.

 

[sabersupra]

Im assuming if the yellow wire was giving off 12v then you would wire a buzzer to that and the ground to the buzzer as well.

That's how I hooked it up. The yellow wire goes to the buzzer and the other wire on the buzzer goes to ground. Still not working:dunno:

 

[Fletch124]

That's how I hooked it up. The yellow wire goes to the buzzer and the other wire on the buzzer goes to ground. Still not working:dunno:

And theres no place for the ground on the buzzer?

 

[sabersupra]

And theres no place for the ground on the buzzer?

The buzzer has 2 wires. One is - and the other is +. The + of the buzzer is hooked up to the yellow of the Profec and the - of the buzzer is hooked up to ground. I tested the buzzer with a 12v source and it works fine. I think the problem is with the analog output option on the profec. I also spoke to a Greddy "Tech" in California who said that this is the way that it should be hooked up, however according to http://www.spooledup.com/content.php?goto=./e01/e01.php the yellow wire emits a ground connection, so I guess I would need to hook up a 12v source to the + of the buzzer and the - to the yellow?

 

[Jaguar_5]

If it gives a ground signal on yellow, then yes that would be correrct, - to yellow, + to a 12v source

 

[sabersupra]

If it gives a ground signal on yellow, then yes that would be correrct, - to yellow, + to a 12v source

When I tried this way, I got an Error code on the Profec. Man I'm stuck.