ok guys right in the middle of my swap for a 1JZGTE motor but i am stuck. i have an 89 that i am putting it in too but the front clip i bought has a hydrolic fan. what are my options?
please help stuck
- Thread starter suprachick22
- Start date
I would upgrade to an aluminum rad with electric fans. Good life choice if your looking to put down some good power.
If you have the full Hydro fan setup use it. I dunno if SupraHero(Jay) is still using his, but that thing would push loads of CFM
3 options: Use the hydro fan, go electric, or mechanical. Each option can work, and each has people who will swear up and down its the best option. I went Electric because i feel the most comfortable with it. Which ever one you choose will work great if you do it right.
Run the hydraulic fan it pushes a load of cfms, it's running at engine rpm. If you have it all i'd use it. I use it and have absolutely no issues and will be using for 600whp I've never overheated and the gauge never moves and using the stock 7m rad. It's four hydraulic lines and a cooler. I'd only use the electrics if you didn't have it all and you were wanting to push 700+ imho.
nick88;1434321 said:
karlmk3;1434392 said:
No, I just replaced the hose that came from the side of the fan to the cooler, because it had been chopped in half by my fan when I blew an ic pipe off pushing it into the fan.
Make sure that you will not blow off ic pipes when using it.
All of it works, I am using the cooler. Put everything off of the clip on to the car you are swapping it into, should work fine.
ok all my lines look fine with that part of the car this front clip was soo clean im just having issues with wiring now lol o well thats the next step ill be using the stock intercoller pipes one of the looks a lil damaged but ill check for boost leak when i actually get the moter installed