Philly Area Supra Meet Part 2 10/04/09
- Thread starter empera
- Start date
just waiting on that slow ass machine shop, they didn't do my rear timing case with the block but they did have the tensioner torqued at least
so i said re do that surface with the timing case on and tyler said he would find out my ra and use the lapping plate they had to give me a smoother surface and let me know what material was removed since the head was machined but by driftmotion and also for the block so i can get this hg ordered
i was looking to go with the baller hks stopper but it depends on how much is material was totally removed
so i said re do that surface with the timing case on and tyler said he would find out my ra and use the lapping plate they had to give me a smoother surface and let me know what material was removed since the head was machined but by driftmotion and also for the block so i can get this hg ordered
i was looking to go with the baller hks stopper but it depends on how much is material was totally removed
Last weekend I cruised up to see if I can find this spot where the last meet happened...but I didn't have the directions with me and I didn't find it. Will try again.
BBQ? Where's the BBQ?
...isn't it supposed to possibly rain Sat?
BBQ? Where's the BBQ?
...isn't it supposed to possibly rain Sat?
chickenz in the pot...next meet.
Since the weather's crappy now, let's pretend this is an online virtual Philly Supras Meet! See that table over there >>> it has the fried chicken on that covered plate.
...OK here's some new stuff I just got. Slightly used HKS twin kit, only a few thousand miles on it. I'm cleaning all parts up, getting everything ready for install after I have all my planned parts in hand...cams, maybe some headwork (still looking into this). My plan is to get two smaller turbos since I want to try getting this setup as responsive as possible. So these two HKS2835's will most likely NOT be what I'll be installing.
Since the weather's crappy now, let's pretend this is an online virtual Philly Supras Meet! See that table over there >>> it has the fried chicken on that covered plate.
...OK here's some new stuff I just got. Slightly used HKS twin kit, only a few thousand miles on it. I'm cleaning all parts up, getting everything ready for install after I have all my planned parts in hand...cams, maybe some headwork (still looking into this). My plan is to get two smaller turbos since I want to try getting this setup as responsive as possible. So these two HKS2835's will most likely NOT be what I'll be installing.
julio,
I went down to that spot you guys had this last meet. Nice spot! I've never been down there until today.
Anybody know how the fishing is along that area? I'm gonna take my kid fishing down there next decent weekend.
I went down to that spot you guys had this last meet. Nice spot! I've never been down there until today.
Anybody know how the fishing is along that area? I'm gonna take my kid fishing down there next decent weekend.
I'll buzz you next time I'm heading in that direction...probably next weekend if it's nice out I'll go for a cruise.