Oil Squirters or Nozzles

debrucer

debrucer

Supramania Contributor
Dec 11, 2006
82
2
8
San Diego, California, United States
myoracledatabase.com
I have only found two references on this site to the squirters; but, none of the information I remember being here. If someone would point me to a link, I'd appreciate it very much.

My block is the "light" version as described in an IJ post. The holes in the block were filled with the following bolts:



Bolts with copper (or brass) washers.

I purchased replacement squirters by part number, so if they're wrong, it's my fault. Here's what I have:



The picture in the shop manual isn't very good, so i searched the net and found this one:



This looks more like what I expected; but, I don't find anything among my parts, nuts and bolts.

There was a reference to a former user who wrote a post on old ones not being reused due to decreased capability... and I can't find it.

Anyone have advice or a link where I can find the answer here? It looks like I bought half of six squirters by part number. Is that correct?

Thanks,

- David
 
debrucer

debrucer

Supramania Contributor
Dec 11, 2006
82
2
8
San Diego, California, United States
myoracledatabase.com
Thanks IJ. This was a K. Wantabe Corp. engine with over-sized pistons and a banana shaped head that had been shaved that way. I was expecting that I had the nozzles and not just short bolts in my block. Guess somebody else thought new ones were too expensive, so took mine :( But, having never seen one, and the only picture a result of googling "supra squirter", I wasn't sure.

Yes, Enraged, they are expensive. I'm not sure which of the two pieces was advised to be replaced with new. I think it's the screws, may be a ball and spring in there... I forget, and I couldn't find the original post. Gads! Another 100 bucks!

Thanks again to both of you for helping.

- David
 
You must log in or register to reply here.
Top Bottom