Need some quick help, a measurement

[jstricker]

OK, the Lemons car I bought as a basket case and have had quite a few missing pieces (duh!!). No surprise there.

Putting the engine in and just realized that I do NOT have the clutch pushrod. I can make one on the lathe with no problem but for some of you that have it out I'd really appreciate you measuring it for length and diameter. I need that ASAP. I've had to find so much crap for this that didn't come with the car and this is just the latest in a long list, but it's coming together and I'll post some pictures of it in the thread a little later.

Thanks to anyone who can help me ASAP, I owe you a beer if we ever meet F2F.

John Stricker
Russell, KS

Edited to add that this is the 154 transmission/clutch. That might be kind of handy to know

 

[jstricker]

Come on guys, surely someone has a clutch pushrod laying out that they can measure don't they???

Please? Pretty please?

John Stricker
Russell, KS

 

[Miiike]

Are you talking about the thing in the slave? If so I have one at home in pieces I can measure for you in a bit

 

[jstricker]

Yep. I'm talking about the short pushrod that goes between the clutch fork and the slave cylinder. Most of it is usually covered up with the boot on the end of the slave. I'd appreciate it a LOT. Thanks.

John Stricker
Russell, KS

 

[Miiike]

Okay I'm off work in a couple hours and I'll measure it for you if no one else has already!

 

[jstricker]

Thanks Mike, you're a lifesaver!!

John Stricker
Russell, KS

 

[Suprapowaz!(2)]

Lenght: 96.86mm or 3.815inches
Diameter: 8mm or .315inches
It's rounded on both ends.

Sorry, had the measurement wrong on the thickness. I corrected it. Decimal was in the wrong place.

 

[jstricker]

Lenght: 96.86mm or 3.815inches
Diameter: 8mm or .315inches
It's rounded on both ends.

Sorry, had the measurement wrong on the thickness. I corrected it. Decimal was in the wrong place.

No problem, I figured as much, and I really appreciate the help.

John Stricker
Russell, KS