Good afternoon, everyone. Over the weekend I installed a '91 7MGTE engine and engine wiring harness into my '92 Non-Turbo Supra. Everything went smoothly with two exceptions.
1. For the life of me, I can't figure out where this connector goes...
It branches out of the wiring harness in the same location as the AFM wiring. Due to the factory heat shielding, I assume it is supposed to be routed/connected near the exhaust, however I can not figure out where it goes. It's quite long, as if it might connect to the Power Steering Pump or Rack, but no available connectors there. Everything else on the engine has been plugged in. Anyone know what it is/where it goes?
2. I purchased a Boost Pressure Sensor from a member on here, and have it installed on the Injector Resistor as it's supposed to be, however I have no connector from my Chassis Harness to go to it. I assume this is because it's a non-turbo car, which obviously would not use that sensor. My question here is what is the sensor used for? Anything other than the factory boost gauge in the dash?
Thanks in advance for the help.
-Chris
1. For the life of me, I can't figure out where this connector goes...
It branches out of the wiring harness in the same location as the AFM wiring. Due to the factory heat shielding, I assume it is supposed to be routed/connected near the exhaust, however I can not figure out where it goes. It's quite long, as if it might connect to the Power Steering Pump or Rack, but no available connectors there. Everything else on the engine has been plugged in. Anyone know what it is/where it goes?
2. I purchased a Boost Pressure Sensor from a member on here, and have it installed on the Injector Resistor as it's supposed to be, however I have no connector from my Chassis Harness to go to it. I assume this is because it's a non-turbo car, which obviously would not use that sensor. My question here is what is the sensor used for? Anything other than the factory boost gauge in the dash?
Thanks in advance for the help.
-Chris
