heh... not really... i just really really wanted a supermonitor and i wanted it to look stock.... and i think i did a good job of that 
My Digital Dash Super Monitor Conversion :D
- Thread starter suprra_girl
- Start date
knight rider, when you do your sm diag check for abs and you get 00 it's because you need to unplug the 2 pin connector at the abs unit
Thanks Tase
Now i thought the whole point of a super monitor was so that you didn't have to get off your ass to check diagnostics! I still need to unplug the abs connector for abs diagnostics grrr. I would have thought that the super monitor would open circuit that plug to check diagnostics?
Now on to the etc side... comes up open/short circuit so i've got to chase some wiring there heh
Thanks Tase
Now i thought the whole point of a super monitor was so that you didn't have to get off your ass to check diagnostics! I still need to unplug the abs connector for abs diagnostics grrr. I would have thought that the super monitor would open circuit that plug to check diagnostics?
Now on to the etc side... comes up open/short circuit so i've got to chase some wiring there heh
Shall I send you the wiring diagramm for the Super Monitor?
I got it...
There is a connection between the SM and the A:B:S: Computer.
the color of the wire is L-G.
It's the same connection, which I found on your "Super Monitor Hardwiring Instructions"
I have no errors..
I got it...
There is a connection between the SM and the A:B:S: Computer.
the color of the wire is L-G.
It's the same connection, which I found on your "Super Monitor Hardwiring Instructions"
I have no errors..
ABS 00 means open or short circuit
you posted in a thread somewhere asking why it said 00 instead of ok, that's why
if you saw my video in my super monitor thread you would see mine is complete... ect & abs is working fine in diagnostics now, i get ect ok and abs ok
you posted in a thread somewhere asking why it said 00 instead of ok, that's why
if you saw my video in my super monitor thread you would see mine is complete... ect & abs is working fine in diagnostics now, i get ect ok and abs ok
it's faulty telling me that i have an open circuit which is correct due to the fact i have no gas tank in there
sometimes my fuel gauege is faultily, too.
I installed a new fuel sender unit.
I think this might be a problem of some electrical capacitors.
They are 15 ore more year old, and after this long time they lose her capacity. Especially on warm days.
If I have remove the Digi once again I will replace all the e-capacitors
I installed a new fuel sender unit.
I think this might be a problem of some electrical capacitors.
They are 15 ore more year old, and after this long time they lose her capacity. Especially on warm days.
If I have remove the Digi once again I will replace all the e-capacitors
so are those in the digital dash?
i have a page from the manual about the error, i can upload later if you want
i have a page from the manual about the error, i can upload later if you want
I am very interested in it.suprra_girl said:
You know I have bought a new Fuel sender unit for the digital dashboard. I hope the sender cannot be the reason for the error...
