I need help to get my A/C working on a 1992 2j swap auto with AEM v2. The compressor is not coming on or getting a signal. When the compressor get direct power it comes on but car still doesn't get cold. No leaks & filled up with gas & oil. The vehicle has climate control. Is there any way to wire up the system to work thru the AEM ?
MKIII 2j swap can't get a/c to work. Need Help!!!
- Thread starter cupit867
- Start date
the aem would only be set to control idle speed.
is the compressor relay outputting power at the relay?
is the compressor relay outputting power at the relay?
the compressor relay isn't getting power but when you jump the compressor to power it works. The problem is the Harness i got made doesn't plug into the body harness from the 7m original harness. Anyway i can hard wire it to work?
hvyman;2051954 said:
Are you using the 2JZ Aircon Compressor? (but with the head off your 7M one)
The 2JZ Compressor has 4 wires coming off it . . . but you can remove all of those - just find the single wire that comes out of the actual compressor itself.
You then attach that to the single wire that comes from the Mk3's Body Loom (near the battery) that attached to the 7M's compressor.
Simple !
The 2JZ Compressor has 4 wires coming off it . . . but you can remove all of those - just find the single wire that comes out of the actual compressor itself.
You then attach that to the single wire that comes from the Mk3's Body Loom (near the battery) that attached to the 7M's compressor.
Simple !
the system needs to be filled and the low pressure switch needs to be good in order for the compressor to be turned on as well
hvyman;2051967 said:
I had to do this as well, my 1J swap didn't have direct power to the compressor so I wired up the relay to the compressor to provide power and the pump turned right over.