JB weld tips

[Big Wang Bandit]

Clean and rough the surface a little?

what else? Ive never used it before. Its gonna seal a crack in a coolant passage on my intake manifold.

 

[Dunckel]

Don't eat it.



Other than that, I think your good. Make sure you mix the resin and hardener well.

 

[Big Wang Bandit]

lol, Thanks Dunkel.

I believe the back of the package says equal portions, Correct?

 

[Dunckel]

I was thinking of a 50/50 mix, so yeah. That should do it.

 

[BorHor]

Put them in between your fingers and wait till it dries to test it out

 

[shaeff]

I was thinking... maybe just put some in your nose until it sets. That would let you know if you can trust it or not.

A sneeze is what... 200mph or something crazy? So, if you sneeze and pop your ear drums, I'd trust it. If it just blows out, then forget it and sell the block for scrap.

 

[Dunckel]

A sneeze is what... 200mph or something crazy? So, if you sneeze and pop your ear drums, I'd trust it.

Unless he has a nasty wax buildup, or he had some JB weld on his fingers and had an itch in his ears, in which case the sneeze would probably blow his head off.

 

[shaeff]

Good enough. At least his family would know it works... right? err...

 

[BorHor]

Well no because the batch he mixed would dry by then. So remember to write down exactly the proportion you use.

 

[Dunckel]

And video the entire thing for liability reasons.

 

[Big Wang Bandit]

 

[Big Wang Bandit]

BTW, Ill let you know how it turns out tomorrow

 

[Big Wang Bandit]

Ok, its on.

Sits for 6 hours, Then Ill check. Ill put the fitting back in the manifold tomorrow. Then start it :X

 

[shaeff]

aaaand?

How's the nose, bud?