Installing gauges

[roadboy]

hey , i need some help wiring my gauges so that they reach to the engine bay.
i have searched and couldn't find an answer.
i have a GReddy boost gauge and fuel pressure, i was just wondering, how do you wire it out to the engine bay.

i have a lotec pillar and i don't have enough wires to pull it to the glove box and out to the engine.
lmk your suggestions/how you did it.
Thanks.

 

[montego6500]

there should be a gromet for the speedo cable, thats what i went through. if that doesnt work can u extend them at all.

 

[roadboy]

does that mean i have to take off the cluster to put it through?

 

[gaboonviper85]

Removing the cluster takes about 7 minuets even for a noob! It's stupid easy, you just need to be careful not to break the plastic bezel around it as it's old and dry rotten!

 

[hvyman]

no just get under the dash and look for the speedo cable. or drill a hole and put a rubber grommet in.

 

[Guyana00]

Taking off the cluster is easy, just look at what screws hold it on and as you go you will see what else is holding it on. Before you know it, nothing is holding it on and it's off.