Injector order question

ronnie4

ronnie4

Member
Nov 25, 2007
136
0
16
38
Huntsville
I'm trying to put he harness back on my 7MGE and need a little help determining which injector connectors go where. I looked at my Haynes manual and it looks like it says:

Cyl1 : White/light blue Yellow
Cyl2: White/light blue Yellow
Cyl3: white/red blue
Cyl4: white/red blue
Cyl5: white red
Cyl6: white red


Cyl 1 is front (pulley side)

Colors refer to wire colors on harness. I tried this order and it doesn't seem to make sense, some on the wires seem to have to be stretched and cross over others.

Harness/motor is an 88
Is that order right?
 
shaeff

shaeff

Kurt is FTMFW x2!!!!
Staff member
Super Moderator
Mar 30, 2005
10,589
10
38
Around
ronnie4;1231161 said:
Dude, your awesome, thanks.
Click to expand...

No problem! :)

jgcable;1231728 said:
while you are at it you might want to replace the injector o-rings and the cushions. Cheap and easy to do.
Click to expand...

Truth. Use some Vasoline or petroleum jelly of some sort to lube the o-rings before you insert them. (The TSRM recommends using gasoline, but the chance of tearing one is still high) When they're in the fuel rail, the injectors should still rotate freely. Don't overtorqe the rail, and don't forget the spacers, either.

If I remember correctly, torque spec on the three bolts for the fuel rail is 13 ft/lbs.

Edit: Yes, 13ft/lbs is correct:
http://cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=89
 
You must log in or register to reply here.
Top Bottom