injector clip adapters

C

cnewingham

Guest
I put in the 550's (low imp. rx7) injectors and really dont want to cut into a new harness (from Toyota) for new clips. I have been searching around and found these - http://www.fiveomotorsport.com/PartsJPEGs/Injectors/ConnectDenso.jpg

what do you think??????

Connector Adapters
NipponDenso Male
to EV1 Female

$17.95 Each

See below for appli. NipponDensoMale/EV1Fem
4/Set $71.80

NipponDensoMale/EV1Fem
6/Set $107.70

NipponDensoMale/EV1Fem
8/Set $143.60

SPECIAL NOTE:
Use this adapter if your fuel injectors were NipponDenso and your new injectors are EV1 with the rectangle connectors.
 
chriso

chriso

Supranian
Apr 5, 2005
917
0
0
Bay Area, CA
Been there, done that. Speak with Bruce at five-o. He hooked me up with them. I made up my own adapters. I think he charged me about $6 or $7 for the nipon denso plugs and I had the Bosch style ones for the RC's and I put them together so if I ever had a problem such as smogging or anything else, I could just swap in my stock injectors again.
p512662_1.jpg

p512662_2.jpg

p512662_3.jpg

p512662_4.jpg
 
joliroger4

joliroger4

Flying Dutchman Pilot
Apr 4, 2005
264
0
16
New Jersey
www.geocities.com
I found myself in the same position as you after replacing my wiring harness. I believe the five-o connectors will work, even though they were pricey, but I never actually ran them so I can't tell you for sure. I made my own after hunting down all the parts to the connectors part numbers from tyco and buying the parts from their distributers.

http://www2.davidconsentino.com:8000/supra/Wiring%20Renovation/Injector Adapters/DSCF0005.JPG

Edit: After looking at the five-0 site, they cut their prices in half since I did this.
 
You must log in or register to reply here.
Top Bottom