Theres a metal fuel line that passes through the 4th and 5th intake runner.....how the hell do you remove this in order to get the head off??
Important Fuel Line Question
- Thread starter born2boost
- Start date
that should be the fuel feed line. one end goes to the fpd on the rail. take out the banjo bolt there. then there is a junction block by the motor mount w/ another banjo bolt. take that one off. there is also a bracket right about the middle holding it to the block.
if you are talking about the other metal line that is the return. take off the banjo bolt at the fpr, then take off the hose clamp at the j tube.
edit- found a pic.
if you are talking about the other metal line that is the return. take off the banjo bolt at the fpr, then take off the hose clamp at the j tube.
edit- found a pic.
look underneath the intake. theres the cold start injector and the j-tube.
disconect them both and there you have it! at least thats the only two i can think of that may be problems.
disconect them both and there you have it! at least thats the only two i can think of that may be problems.
Hmm....can't seem to get that damn banjo bolt out down by the motor mount. Any special techniques to it?
get a long extension. the longest you can find (join up if needed) and go from the top of the 4th or 5th runner down the gap till u get the union bolt. This way you can undo it from the top of the motor, not from underneith it. It took me a few engine pulls to work this technique out so i hope it helps. Its a 17mm socket u be needing.
Don't forget that line is also connected to a flange on the lower intake manifold. SHould be a 14mm bolt or so.
Thanks a lot guys. The extension really worked....don't know why i didnt think of that before. All help appreciated.
