If you're going single soon check this out!

[Evilempire1.3JZ-GTE]

http://www.supramania.com/forums/showthread.php?p=438821#post438821
It is going through and have been approved by shaeff.
I dont know if you know there is a sale going on I want to make sure some 1JZ-GTE guys know this is going on.
If you plan to go single be sure to take an opertunity to buy one of these.

These headers for single conversion on 1jz-gte are only $135! $35 for delivery & if you live in so cal pick them up for only $135

 

[boostindoo]

i just got mine and its off, bottom holes need to be drilled out.

 

[Evilempire1.3JZ-GTE]

The holes dont line up ? did they have this issue with other headers ? and why do they not line up ? are you putting it on the engine with it out or in the car maybe clearence issue i want to know more about these! especialy if i plan to use one myself.

 

[RacerXJ220]

maybe clearence issue i want to know more about these! especialy if i plan to use one myself.

:word8kn:

 

[Evilempire1.3JZ-GTE]

Good news i just talked to lin i might be able to even get these cheaper i am going directly to the source! updates on main thread.

 

[boostindoo]

i fitted it out of the car, top bolts will go through, bottom will not and u will have to cut the studs shorter or use bolts. im gonna take a hack saw to mine. but the it is ported and the welds look very good. they even have tabs to help support it at the flange. u get what u pay for. i rather have one of these than the other manifolds that sell for @300.

 

[935motorsports]

boo

ours are all personally test fitted to fit 100% out of the box.

 

[Evilempire1.3JZ-GTE]

so let me get this right!
The studs rub because they are too long so all you have to do is pull the bottom studs out and bolt it in ?
cool deal!

 

[suprace]

935motorsports, how much are you guys selling the manifold?

 

[suprahero]

935motorsports, how much are you guys selling the manifold?

You should send him a pm or post a thread in his vendor section.

 

[Evilempire1.3JZ-GTE]

935 haves the same manifold and you need to use bolts on the bottom.

 

[boostindoo]

one of the runners run so damn close to the flange its ridiculuos! im probably gonna have to cut a damn bolt in half!