I pulled my motor but the tranny won't come off.

[mrchomponthis]

yeah no fork falling off for me... you are referring to the fork behind the black plate correct? pictures anyone would be so helpful.

 

[Poodles]

If it's stuck....pull harder

Yes, that fork behind the inspection plate.

 

[mrchomponthis]

well I tried that today and pretty much that thing need to be moved by putting a giant c clamp or something because I tried prying it and it didn't move tooo much but it did more about an inch to a 1/2 an inch

 

[Poodles]

Have to remove the slave cylinder first, and pull the fork straight out...

 

[Mk3runner]

yep yep, slave on side then yank fork inside. tranny falls on foot, job done. go to ER.

 

[van1684]

If you still haven't fixed it, look at this picture.

See how the pin is? You take a tiny clip off the top of it and the pin should fall out from underneath. After that the fork will fall off and the tranny will come shortly after.

 

[tlo86]

i dont remember the fork being able to be pulled right out unless you were missing the pin

 

[Poodles]

I've pulled my tranny 3 times, never pulled the pin any of those times...

TSRM says the remove the fork, not the pin.

EPC shows the support that holds the fork is hook shaped (31236B), and the spring that keeps it in place (31234A) Also take note that the fork with the pin and clip is sold as a unit, so if you lose either piece you're SOL...

 

[rumptis]

i dont remember the fork being able to be pulled right out unless you were missing the pin

It just pops right out. I have done this at least half a dozen times.

 

[tlo86]

hrmph, ive actually never taken a r154 out just installed.. i guess that explains it

 

[mrchomponthis]

I got it thanks for all your help guys.