Horrible Throttle response even after tps

[jony89]

So after recalibrating my tps was giving me a very laggy response even worse then before i did. On my multimeter it is set to 200ohms.
Followed the steps on the tsrm, the closes i can get it was .50s. Can this lagg response be somthing else? and i have no codes showing.

 

[hvyman]

What were the resistance values at each step in the test?

 

[jony89]

What were the resistance values at each step in the test?

This is were i messed up. At first i was reading the wrong resistance on the tps and read infinent ohms. When i realized this, i had already loosen the tps. So the settings before i dont know. Yes i know noob mistake but it happens. So after that i tried recalibrating it and .50s was the closes i can get from infinent. ANd this is with a feeler gage between the throttle stop screw. Am i doing somthing wrong?

 

[Backlash2032]

Well with a 35 thou feeler gauge in the stop there should be no continuity between e2 and idl

Sent from my HTC6435LVW using Tapatalk

 

[hvyman]

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=101

Follow that and write down all your measurements and post them.

 

[jony89]

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=101

Follow that and write down all your measurements and post them.

multimeter setting on 2k ohms

between vta-e2 with no feeler .9
between idl-e2 with .5 feeler 1.
skipped step 3 my feeler gauge only goes up to .8mm
full throttle 1.

nothing is correct obviously

 

[Backlash2032]

Well, try to get it correct. Otherwise it's a bad tps

Sent from my HTC6435LVW using Tapatalk

 

[jony89]

Well, try to get it correct. Otherwise it's a bad tps

Sent from my HTC6435LVW using Tapatalk

i tryed recalibrating it so many times but no luck. Car still doesnt idle on its own unless i open the bypass screw on the tb half way open. Abd if it was a bad tps would it throw a code?