Having some problems with My MBC

[frontierguy25]

When I went to the track the other day I noticed that I could only get about 10psi. I checked all my pipes and couplers and everything is fine. So I took out my TurboXS MBC that I have had for 4 years and I could blow right through it. I took it apart as far as I could and everything looked fine. I put it back together again and blew through it again and noticed there is 2 little holes that are in the top covered by a o ring and the o ring wasn't tight any more. Should I just try a new O ring or try and fill those holes. This thing has worked great for me. I had EBC but had several problems with it and this MBC has been great. Any help would be greatly appreciated. This is the one that I have

Thanks

 

[Rennat]

if its not sealed then its probably leaking, so yes, get a new o ring.

 

[frontierguy25]

That's what i was thinking. I'm going to get a new one tomorrow. I'm going to get a new EBC have any suggestions Rennat? I have been looking into the AEM Tru boost to go along with my AEM AF gauge that is on the way. Putting them in a dual a pillar pod.

 

[Rennat]

i'll take that turbo xs MBC off your hands then. haha

i was thinking of going that same route, AEM W/B and AEM Tru Boost

 

[frontierguy25]

i'll take that turbo xs MBC off your hands then. haha

i was thinking of going that same route, AEM W/B and AEM Tru Boost

I think that the gauges together look great! I like to keep everything flowing well with being the same. You have helped in all the threads that I've posted and as soon as I get a EBC I'll send you this one free of charge. Now if I could just figure out this damn clutch deal I'll be set.