got my car back but

BrandonW

New Member
Jun 25, 2007
1,300
0
0
N.J.
this wasn't happening before i took it and it got painted

1. my windows don't go up or down

2. the climate control does nothing (radio works and lights)

3. only the speed im doing comes up no boost oil pressure or rpms

im bringing it back so they can fix it but any ideas to what is causing this?

they said it kept blowing the fuse when using the windows

i know they had the inside door panel off, maybe they crossed a wire or something?:3d_frown:
 

a70Derek

Clean& Simple.
Apr 15, 2007
148
0
16
$an Diego
if the switches on your doors dont work it could be the wiring or just the switches, it happened to me so i replaced both driver& passenger
 

Poodles

I play with fire
Jul 22, 2006
16,757
0
0
43
Fort Worth, TX
They should fix it... but do you trust them to do it RIGHT?

Sounds like the gauge fuse is blowing. If you did the fog light rewire, you usually tap into that fuse...
 

suprahero

naughty by nature
Staff member
Aug 26, 2005
14,971
0
36
54
Roll Tide
They shouldn't be blowing if nothing is wrong though. There's got to be a reason for them to blow fuses over and over.

BrandonW;1084615 said:
they said it kept blowing the fuse when using the windows
 

BrandonW

New Member
Jun 25, 2007
1,300
0
0
N.J.
i'll get some pictures haha its lookin good

and yes they are going to fix it since there were no fuse or electrical problems before my car went there, and no i did not do any fog light mod

if this helps i have no idea but there sounds like something buzzing every no and then near the charcol canister!?:aigo::1zhelp:aigo:

im just trying to get some imput so when im like fix this because nothing was wrong before i can maybe give them a better idea of what to check
 

BrandonW

New Member
Jun 25, 2007
1,300
0
0
N.J.
if so it wasn't much i know there was a little frame damage they pulled out or whatever so if there was a little bit of welding it would have been by the front lower passenger side where that crush bumper would connect
 

Who

Supramania Contributor
ilikebigbutts;1084878 said:
did they do any welding on the car?

+1 on the welding idea. Welding current or any current for that matter will seek the least path of resistance. If the welding ground is not placed close to the arc, the current could seek another path and damage other electrical equipment. Some recommend removing the negative battery cable and disconnecting the alternator.