General Maft Pro

[mhopemk3]

I notice when I start my car (or turn the ignition on).. The maft pro is reading the setup page.. I used to have it on the sensor monitor page and it always stayed there..

Is there a battery on the board that would retain this setting??
The wires are connected with the taps (Bad I Know) so I know there is a possibility of a loose connection. Just wanted to ask before tearing out the glove box.

My setup does remain so this doesn't seem to be causing any issues..

 

[loki2043]

hold the middle button in and press the left buttons i believe until it says sensor display or something like that.

 

[shaeff]

read the directions.

-shaeff

 

[mhopemk3]

hold the middle button in and press the left buttons i believe until it says sensor display or something like that.

Thanks for that technical advice.. I know how to get it back to the sensor page but it wont stay there..:icon_razz

 

[turbobob]

what software version are you running?

Try re-initializing the unit and re-entering your tune.

Bob

 

[mhopemk3]

Thanks Bob, I am using 4.80. I was going to try that but I forgot the laptop at the office. I will post the results..

Matt