I was trying to figure out how to install my brand-spanking new oem wiring harness without modifying it to fit my 550cc injectors, and I figured out a pretty straightforward way to do it, and I figured some other guys would like a way to install 550's without having to hack up their harnesses. Well, here it is.
As you can see in the picture, I put together some jumper harnesses which are installed between the existing wiring and the upgraded fuel injectors. While they are not directly plug and play, all that is required is to de-pin the stock injector clips (using a 1.4mm precision screw driver) and insert the pins into a new supplied clip, plug in the jumper harness, and you are good to go. The harnesses are sealed and crimped using the correct tool. I'll put together some pricing in a day or two if there is enough interest.
here is a picture - i'll get one of the wiring harness as soon as I can.
As you can see in the picture, I put together some jumper harnesses which are installed between the existing wiring and the upgraded fuel injectors. While they are not directly plug and play, all that is required is to de-pin the stock injector clips (using a 1.4mm precision screw driver) and insert the pins into a new supplied clip, plug in the jumper harness, and you are good to go. The harnesses are sealed and crimped using the correct tool. I'll put together some pricing in a day or two if there is enough interest.
here is a picture - i'll get one of the wiring harness as soon as I can.
