Funny Supra incidents

[Bootymeat]

HELP!! I'm bored at work! I work at a local shop, and not too long ago I had a FINNEE college girl come in to get her oil changed. Well I was under the hood of the Supra until WHAMM!!! The hood shocks decided to shit on me at the most awkward time. I was so fucking confused and she was laughing her ass off. :3d_frown:

Post up I'm bored!

 

[gaboonviper85]

Pulling my trans from my na, I was laying on the floor with my head near the tail housing...as I was lowering the trans while it rested on my knees, fluid started pouring out all over my face and chest. Trans fluid sucks!

I've had a hood come crashing down on my head before...indeed it sucks!

 

[karlmk3]

first time i opend the trunk on mine standing with the lady and the kid. the guy selling it doesnt tell me the shocks are bad and wham that mother fucking trunk is heavy :: angry ::

 

[Bootymeat]

Pulling my trans from my na, I was laying on the floor with my head near the tail housing...as I was lowering the trans while it rested on my knees, fluid started pouring out all over my face and chest. Trans fluid sucks!

I've had a hood come crashing down on my head before...indeed it sucks!

HAHAHA I un-voluntarily ate tranny fluid before, with my co-workers Laughing so hard they drop tools and buckle over. :biglaugh::biglaugh:

 

[RazoE]

haha, I had the hood fall on me a few times, so I did the only logical thing..


replaced the shocks..!

 

[CajunKenny]

Broke my left collar bone while trying to remove a crank pulley bolt. I had a 3' chunk of pipe on the end of a breaker bar for more leverage. I got more leverage alright. Enough to break the breaker bar and have the cheater pipe come smashing in to my collar bone at the speed of sound!

Not only did it break the bone, I almost bought myself some stitches because of a cut from the edge of the pipe.

I can't remember the last time I hurt that bad.

That crank pulley bolt is still on that engine. :biglaugh:

 

[NTRA08]

I usually keep my driver window down. I went to get in the car and leaned forward and hit my forehead on that little triangle piece where the window and mirror meet a few times

 

[lewis15498]

Broke my left collar bone while trying to remove a crank pulley bolt. I had a 3' chunk of pipe on the end of a breaker bar for more leverage. I got more leverage alright. Enough to break the breaker bar and have the cheater pipe come smashing in to my collar bone at the speed of sound!

Not only did it break the bone, I almost bought myself some stitches because of a cut from the edge of the pipe.

I can't remember the last time I hurt that bad.

That crank pulley bolt is still on that engine. :biglaugh:

That sucks. Always push away from you when using a cheater bar.

 

[KORYTOYORTA]

my friend just bought a 240 an he got pulled over because of the exhaust.... he happend to have 2 airsoft guns in the back seat so the cop told him to pop his trunk and get out of the car he told the cop that the shocks where bad on the trunk but the cop opend it and reached in to look under some stuff an the trunk fell on the cops head hard he said he couldnt stop laughing even though it was getting him into more an more trouble

 

[staticpage]

first start up after the swap open down pipe no air filter, a buddy comes over and bends over the pass side of engine bay with 1j running and says "open down pipe its quiet rev it" I rev the piss out of it, bouncing of red line. He jumps back hinting his head on hood holding his ears and falls over my pile of parts.
we laughed for weeks over it

 

[SupraMario]

I seem to always hit my head on my gauges...I'm not used to them being there.

 

[nick88]

Jumped in the engine bay of my parts car with no engine to get the slave cylinder, and the hood slams shut and I'm in the engine bay. lol. I just climbed out from under it because it was in sport mode in tems when we took the engine out and I could climb right out from under it.

 

[CajunKenny]

That sucks. Always push away from you when using a cheater bar.

I tried; but, my feet kept sliding across the floor. It was ridiculous!! So, against my better judgement I pulled toward me.

That thing must be JB Welded on there!

 

[karlmk3]

Jumped in the engine bay of my parts car with no engine to get the slave cylinder, and the hood slams shut and I'm in the engine bay. lol. I just climbed out from under it because it was in sport mode in tems when we took the engine out and I could climb right out from under it.

that is about the best thing anyone can picture beening pined under the hood... bro you had no horse power but 1 manpower haha ok shuting up. full of dum jokes tonight

 

[kabanimk3supra]

I tried; but, my feet kept sliding across the floor. It was ridiculous!! So, against my better judgement I pulled toward me.

That thing must be JB Welded on there!

you should have used the starter to break it loose...It might be the right way to do it, but it works like a charm. no broken bones, no stripped bolts, and no broken ratchets.

 

[CajunKenny]

^That's what I tried first. No dice... I'm sure I had more on it with the breaker bar and pipe than the starter could do.

I'm telling ya. That thing is ON THERE!

 

[dumbo]

This thread needs to be renamed....

Stock struts need replacement

 

[CajunKenny]

^Uh oh! To what?

 

[dumbo]

^Uh oh! To what?

Um...New..

Paid I think 37$ for somethin(Can't remember the name brand, Monroe?) Good for over a year now, would pay that every six months....Can't spare the brain cells....

 

[Jayhall]

Droping the 1J into place, checking to make sure the motor was clearing the rad support, got excited and stood up way to fast. Smashed my dome on the cherry picker and KO myself.... infront of about 10 other people too. Only once, that really hurt