Does anyone know the specs of the bolts (length, thread spacing, etc.) used to fasten the fan clutch to the water pump pulley? Also, I need to know the specs for the nuts used to attach the fan to the fan clutch. Thanks!
I am a long way from my car, but would be suprised if it wasn't 8 x 1.25. From memory, the wrench is 12, making the stud 8. Very typical Toyota, most are the same.
The shop that last replaced my water pump just used bolts to connect the pulley to the water pump. I had electric fans so there was no fluid coupling. Looks like I'll be ordering more little bits and pieces again.... :3d_frown:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.