Engine wont separate from bell housing please help

[917mgte]

In the process of doing an engine swap and i have everything disconnected from the engine and all the bell housing bolts out but the engine wont come apart from the bell housing help!!!!!!!!

 

[gennro]

You need to disco the clutch fork...... http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=MT&P=5

 

[GrimJack]

Have you removed the pressure plate bolts or pulled the clutch fork?

 

[87M-GTE]

Hit it with a rubber mallet

 

[92TealSupra]

Hit it with a rubber mallet

... don't hit it there is a reason, either, pop off the c-clip on the clutch fork and pull the shaft that holds it out, or disconnect the pressure plate from the flywheel.

 

[frax]

I had the same problem, listen to what has been said: Pull the pressure plate bolts or release the clutch fork.

Spent hours trying to figure out WTF was gong on before realizing what was wrong

 

[917mgte]

ok thanks alot i will try and release the clutch fork

 

[Muzy]

ok thanks alot i will try and release the clutch fork

Hope you ment remove clutch fork? Yes I'm sure you did. muzy

 

[Poodles]

... don't hit it there is a reason, either, pop off the c-clip on the clutch fork and pull the shaft that holds it out, or disconnect the pressure plate from the flywheel.

No, just PULL on the fork.

 

[917mgte]

Yeah i meant pull the fork i was in a hurry this morning haha