i just bought a mrt elecronic boost controller i got it all installed i am now in the process of tuning it i cant get the thing to hold steddy boost in higher numbers above 10 psi the needle will go up and down with in a few psi of the set psi the manule calls it surging or hunting it also says it could be a result of useing to much vacume line or by useing the wrong size can some one please help me out give me any ideas you might have thanks
electronic boost controller problems
- Thread starter daren
- Start date
man that was a hella long sentence no periods or anything ive dont have experience with MRT but it sounds like you need to adjust you duty cycle up or down i forgot which one but i think it is up or maybe you have to raise your boost limiter i know my profec b spec 2 is like that or it could be your vac lines are too long like you said man its hard to type without periods kthxbye
what do yo mean by duty cycle the only adjustments are a high and low boost calibraters and some sens adjustment