Can someone tell me what is going on (beside the terrible tune):
The car was revved to 6400, I watched, but the graph shows a max engine speed of just under 5000 rpm. The operator seemed to think that it was my gauge that was busted, but that is not possible since my avc-r picked up the exact same (correct) rpm of 6400.
So then, was the dyno incorrectly reading rpm? (seems likely)
How will this affect my torque readings? (should be inflated?)
How will this affect my hp readings? (should still be accurate?)
HELP!
My Mods:
stock ct-26 - 14psi
550cc inj
walbro 255
hks ssqv
hardpipes + spearco replica intercooler
built bottom end -bored 20 over with forged rods (don't ask)
ngk plug wires
ultima red top battery
aeromotive AFPR
NO FUEL MANAGEMENT (hence the terrible tune, my afc-II was shit when I bought it second hand)
hks megasuperawesome flow filter
avc-r (but the runs were done on a manual boost controller since my avc-r may also be screwed (bought from same guy))
full 3" exhaust with hi-flow cat (including downpipe and turbo elbow)
)