Driveshaft Removal Problems...

[87Superdupra]

labled? Oh yeah, I havent done that yet HAHAHA Im just labeling the injector wires, the rest of mine is plug and play, you cant mix anyting up with mine.

The vacumm lines are all geting replaced anyways, I think Ill be ok, its jsut a mess.

I say a prayer for ya man, I'll need one too!!!!

 

[suprarich]

Much eaiser together, forget pulling the motor alone. You need a spread bar like you see in my pic to tilt the motor the correct angle to clear.

 

[phoenix6]

You got those off? You might have smaller hands than me and I proved with my fuckin corsica that I could get anything, hot or cold engine. Damn. Im buyin ur ticket, come help me take my shit out haha.

Prayer commenced to SupraGods

 

[87Superdupra]

trans+motor at same time sounds easier...engine is totally ready to come out what on the trans needs to be loosened/taken off?

 

[supramike7m]

take out the shifter, unbolt the suupport bolts, unplug connector(3 or 4 if its an auto, speedo, linkage if its an auto, cant really think oof anything else its been a while. not a whole lot though.

 

[drjonez]

...Id pull the motor and trans at the same time, way easier.

bingo.

 

[whudafux]

the 2 tranny bolts at the top of bellhouse behind the head were the biggest bitch I have ever experienced in my life to get off IMO

i had no problems getting those 2 off. But thats because i pulled them both. Believe me, its much easier to pull them both.