drive shaft stock limits?

[IJ.]

that's sweet IJ. what all is done to that?

-t3d

Strange Weld Yokes, Hardy Spicer 1350 Slip Yoke, 1350 UNI Joints, New Centre Bearing, 3" tube (from memory)

It put me below critical with the 4.11:1 I ran even up to the RPM limit of 8300 I used back then so it well under stressed with the 3.5:1 I run now and 6200 redline.

 

[whenmunkysfly]

i don't see it as a problem of look at all the people who are doing it and are doing ok. i see it as a "the guys who know what they are talking about say its a bad idea"

now if a one peice works for you great. but for me I like my sustained highspeed runs and seeing as I have been racing all my life there is no doubt in my mind my car with see the track a few times.

vibrations dont bug me as long as they dont get out of hand when does bug me is the possability of my driveshaft cutting a hole in my floor(seen it happen a few times). even more so if i have someone sitting in the back and they get hurt

...nice stuff IJ