code 11....wtf

j3r3my

New Member
Jul 19, 2010
240
0
0
mass
well to start its a 88 with a rebuilt 7mgte with a safc and its basicly all stock,stock maf,injectors and i havnt messed with the safc yet.. with that said the car was running fine untill today i started it and went to give it gas and it bogged out and almost died so i let off..tried again and held it threw and it just jumps idle like a gay honda with launch control..also on the safc its saying im giving 30-50% throtte and my maf is only reading 3hz on the safc when it should be around 30hz...i tried to force ground the i.m ground right to the battery and no dice codes still on..what other methods should i try? i obvs tried to search but cant find anything that will help..

any and all help is appreciated!
 

j3r3my

New Member
Jul 19, 2010
240
0
0
mass
im from fall river mass any help is appreciated guys..and everything was fine before the fact of it being rebuilt it just needed valve seals..and what could i do to test the maf and also when i reset everything remove the + terminal and such clear everything i get codes 31(afm) and 51(no idl signal?) and after running or reving it goes right back to code 11..im stumped on this one and its driving me nuts the whole dam motors new and i never had issues before the fact! and worchester is like 45 minutes to an hour away from me and idk about easton but your help is appreciated guys!!
 

j3r3my

New Member
Jul 19, 2010
240
0
0
mass
Yea starts fine..timing good..the reason for it reving kotu came by and my dam knock sensor wasn't on..but I still can't figure out why my safc is reading 30% throttle when the tps isn't even hooked up and my afm isn't reading neither and its all wire correctly..its weird..again any input is appreciated