i just replaced my slave cylinder and i still cant get and pedal out of it? me and my friend bench bled the master cylinder and it was good but i can figure out why i can get any pedal?
clutch
- Thread starter supratoyota18
- Start date
how are you bleeding it?
with a hose into a bottle to see the air bubbles come out? or just pump the clutch with the bleeder open?
with a hose into a bottle to see the air bubbles come out? or just pump the clutch with the bleeder open?
supratoyota18;1069570 said:
If it's not and you're getting fluid pushed to it... you'll know cause there will be a puddle of hydraulic fluid under the bell housing and inside...
well then its in there because there was no puddle. yes i was open bleeding it? should i use a hose and a bottle?
i've always bled stuff with 2 or 3 people.
one inside, one watching the master cylinder making sure there is enough fluid in there, and one under the car turning the bleeder.
i would let it gravity bleed for a bit, and then connect it up, and then open the bleeder and push the clutch in, and then you tighten the bleeder before it stops shooting out air so that way it doesnt suck air back in. which is why i suggested the bottle method, i've NEVER had a problem bleeding any clutch like that.
its just my method, im sure somebody has another idea.
one inside, one watching the master cylinder making sure there is enough fluid in there, and one under the car turning the bleeder.
i would let it gravity bleed for a bit, and then connect it up, and then open the bleeder and push the clutch in, and then you tighten the bleeder before it stops shooting out air so that way it doesnt suck air back in. which is why i suggested the bottle method, i've NEVER had a problem bleeding any clutch like that.
its just my method, im sure somebody has another idea.
im going to try again tomorrow hopfuly my friend has his gtm off the lift so i can use that. i had fluid coming out of it but it wouldnt build pressure.
pump the clutch a couple times then hold it down, then while its held crack the bleeder for a second and close it again. Pull the pedal off the floor and pump and repeat until no air comes out.
still will not build pressure? WTF i pump bled pump bled. I gravity bled it and all an still wont build any pressure?
i noticed if i pump the pedal fast it builds some pressure but it leaks out or somthing when u hold it to the floor?
yeah thats what we just found out i guess i be ordering a new one tomorrow. thanks for every ones help