cel 24 on a 90?

[boosted2085]

im getting cels 22,24,51...i no my temp sensor is bad it wont give me a reading,51 prob a bad tps..but a 24 on a 90? when i checked the manual,motor,and sm i dont see a iat sensor,at least not before i went speed density..but i got that code before the maft pro?

any ideas?

 

[dbsupra90]

it is inside the afm.

if you have that code since the mpro install, that is typical. you need to put a 1.2k resistor between THA and E2.

here is the pinout on my website if you dont have it. THA should be a light green colored wire and E2 is brown.

http://www.mk3.us/dave/tech/supradiag89.jpg

51 is tps, probably dont have it adjusted right.

 

[boosted2085]

also when im crusing it runs ok but wot i hit fuel cut..boost hits fuel cut from 10.8psi down to 9.2psi..due to tps?

 

[dbsupra90]

i used a 1/2W resistor. direction doesnt matter, its NP.

the tps itself wouldnt cause that issue. but if it is far enough off that the mpro isnt going into the high throttle map, its possible maybe. but only b/c of tuning. i hope that makes sense.

it would be real helpful if i could see your bin file and a log.