does any one know why this would happen. here's a list of mods i have: stage two crower cams crower springs,fidanza cam gears, titan motorsports head gasket 1.4 mm, arp studs torqued to 80footpunds. three inch down pipe and three inch all the way to the back k&n air filter, blow off valve, aem afr gauge, auto meter boost gauge, I'm pretty sure i got it all. i have had an idle problem ever sine i pulled the head and installed the cam and head gasket and all i have a good compression reading when i tested the compression i have clean the manifold and replaced iacv hoses and cleaned that also. i didn't get the cams proffesionaly tuned bc know one around here can do it i live in civic world and i have a supra ))))) ::w00t:: well i installed the cams just with the marks aligned and i tuned from there to best of my knowledge where i have them now they run the best but still it stalls sometimes my lower ic pipe on the compressor housing is cracked so i need to replace that but i think i got it not leaking air but i need to fix it for good. today i was messing with the car looking for a vac leak to see if thats why it stalls well i figured i would give it a vac leak so i pulled the vaccuum hose off the end of the manifold that should of made it cut off but it just started idling smooth and i revved it and it goes back to idle just fine so i'm so confused if any one can help me thanks alot i also take texts bc i cant get on here alot 706 984 3014 thanks for any help p.s. i have moved the cams every which way just to see what happens and i have the best results where they are now