Boost Controller Install ?'s (Turbo Pressure Sensor Vac Line?)

[Fubar231]

I have a question about the EBC im about to be installing here on saturday. Reading the installation manual it says T the 4mm vac line off the FPR Vacume Line and run it to the EBC (For the built in , but needed , boost gauge).

My question is, can i just tee it off somewhere else thats close? I'd rather not cut up my FPR vac line, and just T it off a vac line that im already using for my boost gauge.

Is the FPR vac line going to be more precise/responsive than another vacume line?

I have my boost gauge tee'd in off of my turbo pressure sensor vac line.

Holy shit my engine bay looks filthy in this picture...

 

[IJ.]

Any boost source is fine, keep in mind though depending on which side of the IC it's plumbed to the reading will be different due to the pressure drop across the IC.

 

[Fubar231]

Do you know where the vac line for the turbo pressure sensor runs? I installed the boost gauge in that line... so long ago. At least a year and a half ago. But do you know where it runs? Just trying to figure out where the turbo pressure vac line runs... Time to go scan through cygnusx1 for a while.

Thanks for the quick reply too IJ

 

[IJ.]

Nah sorry never owned a GTE so NFI.