Bolt size for the r154 clutch slave cylinder?

[7thousandpiecesMGTE]

searched but to no avail... the bolts that mount the slave cylinder

If you know it please post it: size, pitch, and length.

I think they are m12 x 1.25 but I dont know this for sure and do not know the length.

thanks

 

[Satan]

Easiest thing to do is to put a bolt into the hole and make sure that the bolt goes in far enough to not "bottom out" when the slave cylinder is attached. Good luck!

 

[IJ.]

More than likely be m8x1.25 Andrew, m12 is headbolt size

 

[7thousandpiecesMGTE]

More than likely be m8x1.25 Andrew, m12 is headbolt size

Ah crap, you are correct.... m12 bolts would be for a beefy slave cylinder!!! I'll try some m8x1.25 and see if I can figure out the length. Thanks guys.

I'll post it up for future reference when I figure it out.

 

[supra1008]

Length is about an inch I believe. Maybe an inch and a half.

 

[IJ.]

Ah crap, you are correct.... m12 bolts would be for a beefy slave cylinder!!! I'll try some m8x1.25 and see if I can figure out the length. Thanks guys.

I'll post it up for future reference when I figure it out.

LOL wouldn't ever fall off

 

[7thousandpiecesMGTE]

8mm x 1.25 is correct, length was 20mm (at least thats what I used and it seemd to work just fine)

 

[GrimJack]

FYI, these can be had from the dealer... part number 90080-10055, should be about $0.71 each.