For those of you that have mounted your MAFT blow thru, where did you place it & what size did you use?
Blow thru MAFT
- Thread starter rakkasan
- Start date
Orion ZyGarian said:
Yeah, but how? 2 1/2 - 3" reducers on each side? I'm planning my install & want to do a blow thru, but I think that using reducers on each side would screw with the airflow, right?
2.5 to 3.25 actually.
reducers wouldnt cause enough turbulence to worry about, and also there is a honeycomb inside the maf that is supposed to reduce turbulence/straighten airflow.
yes you can mount right before the throttle body or on the throttle body for that matter and use a 3.25 to 3 or 3.25 to 2.75 reducer.
however, on my setup i tried to keep as far as possible from the heat of the motor and exh manifold and also from electrical noise of plugs/wires/coils. being a elect tech i always avoid heat and noise as much as possible.
here is how i did mine. will be changed soon when ffi goes on.
hope this helps
reducers wouldnt cause enough turbulence to worry about, and also there is a honeycomb inside the maf that is supposed to reduce turbulence/straighten airflow.
yes you can mount right before the throttle body or on the throttle body for that matter and use a 3.25 to 3 or 3.25 to 2.75 reducer.
however, on my setup i tried to keep as far as possible from the heat of the motor and exh manifold and also from electrical noise of plugs/wires/coils. being a elect tech i always avoid heat and noise as much as possible.
here is how i did mine. will be changed soon when ffi goes on.
hope this helps
Dylan :bigthumb: on your photos
I've seen them before, link from some other thread. Just wanted to give you props
I've seen them before, link from some other thread. Just wanted to give you props
Silicone intake systems are well priced and have 4 layer silicone couplers and t bolts and whatever you need..Google the name of the company hope this helps