Anybody know anyone who makes one? I run a stinger 4 so don't require a stock one. Trying to clean up the engine bay a bit. I don't want to make one (don't have the tools for it) but maybe Randy or Aaron might be willing to make one:naughty:
Block off plate for ISCV 1JZ?
- Thread starter Van Diesel
- Start date
I made one out of 1/4" aluminum by tracing the ISCV, then cutting it with a hacksaw, and rounding the jagged edges with a dremel. Then I just drilled some holes and I was all set. Only took about 15 minutes.
thing is I have to order 1/4" aluminum (not buying that crap on the Italian economy...especially with the Euro being so strong when compared to the dollar). I've made BOP's before. Just checking to see if anybody knew of any vendors that already pre-made some.
Anybody want to make me one?
Anybody want to make me one?
Maybe give Big Aaron a call and see what he can do for you? I would think that that BOP would be the easy part. The tough part would be finding all the needed fittings to block off all the lines that go to the ISCV.
nah. There are 2 water lines going into the ISCV. I can either loop them together or use a silicone cap to cover them completely.
