Anyone know what these are for?

[supra1008]

This is a harness. The four pin connector goes to a connector located in the passenger fender near the air filter. Where do the 2 two-pin connectors go to? What are they for? Any help would be nice. Thanks.

Chris.

 

[Supraflymk3]

I believe they plug onto the ac line running right below the strut tower. i ripped my ac out so i have those plugs disconnected.

 

[Supraflymk3]

Otherwise one could be your foglight plug. im on my phone and cant look at the pics big. one could also be for a washer pump.

 

[supra1008]

Otherwise one could be your foglight plug. im on my phone and cant look at the pics big. one could also be for a washer pump.

My foglights work and my washer pump works normally. I don't know if someone jumped the wiring so it would work. There are three big connectors in that fender. I hooked up one and my blower fan works now. The only things that don't work is my ABS, Cruise control, AC, and airbags. But I think the AC will work if I reconnect the compressor and hoses and recharge it. I haven't checked yet. It's been too cold.

 

[Asterix]

There are two A/C pressure switches in that vicinity.
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=AC&P=32
These connectors may go to those.

Asterix

 

[Supraflymk3]

Your cruise control connector is on the driver side by the firewall so its not that. could be your abs connector for the pass side.

 

[Moy]

Or possibly the plug to the tems motor (if you have a tems car)

 

[supra1008]

I was thinking ABS... My car didn't have tems.

 

[supra1008]

one of the two pin connectors is long enough to stretch across the to the drivers side of the car. it looks like it would go to light. My headlights, foglights, parking lights, turn signals, and headlight motors all work. What else could it be?

 

[supra1008]

I realized what they are for. Its for the front abs speed sensors. Thanks guys.