Can I just Buy 2.5" IC pipes? because I will upgrade my Turbo...Eventually But right now I have 3" pipe to Stock CT 26 and it's lagging, everyone says I should have 2.25" but that means another set is needed someday. So I just want to...NOT have to buy a bigger set when I upgrade my Turbo. Anybody Else run 2.5" with a stock CT26?
Anybody Run 2.5" IC pipe on stock Turbo?
- Thread starter 87Superdupra
- Start date
Also, I need to Buy an IC pipe kit...but I just Bought a Spearco Replica IC, so I was wondering Where to Find Aftermarket pipes for an IC that is setup like the stock IC (Inlet/Outlet on same side)
I've got 2.5" pipes on the Spearco Replica IC. I'm running 9psi with a 3" cat-back, a DDP is in the near future. Not too laggy, didn't notice much of a difference in lag from stock.
I just finished making my 2.5" pipes with the spearco replica ic. My car isn't running yet, so I can't say how they are. I'd buy the piping kit from DriftMotion, it comes with all the pipes and couplers needed.
Thanks, will go with IC pipes on Driftmotion. Will the Replica Type-S BOV they sell be ready to install as well?
i have 2.25" with a spearco replica and i didn't notice any problems or more lag, if anything it seemed to respond faster.
but you asked about 2.5 so that's just my $.02
but you asked about 2.5 so that's just my $.02
I know a few people with 2.5's on stock turbo. It's not much more lag than usual, very tolerable. I am getting that setup soon.
i put a giant 12x24x4" IC = 2.5" pipes with the stock ct26 and i was getting considerable lag, although it did flow much better and made more power (at less psi)... now i got a bigger turbo tho 