AFPR Install on 2JZ fuel rail

crazysupra2JZ

crazysupra2JZ

New Member
Nov 16, 2006
740
0
0
Georgia
i've been searching but i can't find what i need. what do you do with the fuel rail return port? do you have to tap the hole or do you attach something on the existing FPR? i just bought an Aeromotive FPR and i have a nifty little gauge and now i don't know what to do. i know how to hook it up, but HOW?

thanks guys
 
Evilempire1.3JZ-GTE

Evilempire1.3JZ-GTE

SF what a waste of supras
Jun 22, 2006
1,382
0
0
SoCal
www.myspace.com
you remove the old fpr get the adapter metric to AN then run hopefully a -6AN to the regulator you dont need the larger one unless you have a lot of power on your 2jz setup.
What i mean by this is there is 2 diffrent types of afprs.

run the vacume line that went to the old fpr to the afpr then plug your return line into the bottom hole on the afpr and adjust it using a non-liquid type because aeromotive haves an artical on how the liquid ones are not as acurate but it have been said that the non liquids are more likely to break do to shock.
 
hottscennessey

hottscennessey

DONT BE A BITCH!
Jun 3, 2005
3,137
0
36
37
Richmond, VA
I have a 2JZGE, but the FPR is setup the same way (2 bolt flange, and tube with o-ring). All I did was take a 12x1.25 tap to the hole (no need to re-drill) and then I used a -6AN to 12x1.25 adapter.

http://www.anplumbing.com/shop/index.php
P/N: 991945


intakemanifold001cq3.jpg
 
crazysupra2JZ

crazysupra2JZ

New Member
Nov 16, 2006
740
0
0
Georgia
well, i ordered an adapter from Sard and should be here next week. i was thinking abou your idea hottscennessey but i was worried about getting a good seal that way. AN fittings seal on the beveled surfaces and i can't make that inside the fuel rail
 
You must log in or register to reply here.
Top Bottom