7M-GTE, Vacuum; Where does this go?
- Thread starter iskrem
- Start date
It goes up, and through a little straw like pie, then to the EGR pipe that also shows nothing connected in front of the 3000 pipe.
Take a look at this diagram:
http://www.cygnusx1.net/supra/Library/EPC/291420/catalog.aspx?F=2211&P=2
The vac line attaches at the end where it shows 22230X to a small vertical hard pipe (22205)...another vac line goes from the other end of that hard pipe to the vac hard pipe in front of the 3000 pipe as shown above. The pipe marked 22205 mounts on the head iirc.
http://www.cygnusx1.net/supra/Library/EPC/291420/catalog.aspx?F=2211&P=2
The vac line attaches at the end where it shows 22230X to a small vertical hard pipe (22205)...another vac line goes from the other end of that hard pipe to the vac hard pipe in front of the 3000 pipe as shown above. The pipe marked 22205 mounts on the head iirc.
I have never seen the stud (90116-0827) where the nut was not firmly locked in place. They usually come off together, as if they were made together.
if i remember correctly, there is one two-plug wire in that area that does not connect to anything.
Adam could be right, or that could go to your transmission. But, by the loose brown plug in that picture, I take it you are still in the planning stages of your vacuum.
The transmission is wired with two single wires and one four-plug. This two-plug is the only thing left down there that I have no idea where goes to.
I think it plugs into the egr sensor thing on CA only cars. Im guessing, but my car actually had the sensor there, but I didnt have the actual wire coming out of the harness for it. (I think my harness was changed possibly to a non CA)