Hi, I was just wondering if theres anything wrong in these pictures? Thanks (Mainly BOV and other hoses/lines)
2jz Engine bay. Anything wrong here?
- Thread starter chopstickz
- Start date
chopstickz;933918 said:
Sure. You can buy a better set of IC piping and get the BOV welded on in the correct location as well.
jza71;933964 said:
Nope. Its is okay in the piping but potential for boost leaks has trippled with this setup. A nie welded on system can be better.
Blow off valve will be protecting the primary turbo from surging. However, the secondary turbo doesn`t have anything protecting it. Secondary turbo need a BOV in its` charge pipe. Failing that just place the valve before the throttle body!
wow theres some wacked out responses in this thread.
other than the fact that its a kludge and there are cleaner ways to install an aftermarket BOV, that engine bay looks fine and should run fine.
if you dont like the way it looks either put the stock BOV back on, or get some hard pipes to replace the stockers.
other than the fact that its a kludge and there are cleaner ways to install an aftermarket BOV, that engine bay looks fine and should run fine.
if you dont like the way it looks either put the stock BOV back on, or get some hard pipes to replace the stockers.
