1JZ fuel rail question

[GeneStarWindGSW]

I know both the inlet/outlet of the fuel rail on a 1jz is 12mm x 1.25 but instead of buying a "12mm x 1.25 to -6an" fitting (because i don't want to use SS lines).

That if i could use this instead

http://www.pegasusautoracing.com/productdetails.asp?RecID=5081

and this

http://www.intengineering.com/12MM-to-6-Hose-Barb-Banjo-p4748051.html

Would this work out fine, so i could use fuel hose lines /w clamps?

 

[RacerXJ220]

the concept is right. Those fittings appear to fit into one another.

 

[GeneStarWindGSW]

the concept is right. Those fittings appear to fit into one another.

Yea i ordered them both, I'll see how it works out.

 

[johnd]

Correct me if i'm wrong, but isn't there an O-ring that seals the stock fitting.

 

[GeneStarWindGSW]

Correct me if i'm wrong, but isn't there an O-ring that seals the stock fitting.

yea the stock fitting comes with an o-ring, i just used 12mm crush washers on each side. It worked perfectly.

I'll take photos of my setup when i get a chance.