1jz 7m bell Housing May Have Found The Problem!

[92TealSupra]

Okay everyone. I have this gap with my drive shaft could I have a 1jz bell housing? or nope..

I am not sure so.. please!! No yelling at me.. what is the difference isn't it like 20mm or cm?


Also are the engine to transmission mounts different for auto trans and manual trans I can get the exhaust side one to fit but the intake side I cannot?

 

[IJ.]

You might have a Jz bellhousing if you have a Jz motor otherwise no.

 

[92TealSupra]

You might have a Jz bellhousing if you have a Jz motor otherwise no.

Alright, well I don't know if this is the original trans I imagine it is though. It was just an Idea, I don't know why that drive shaft.. is like that then..

 

[Highnitro]

couldnt that be an auto driveshaft with a manual tranny, i might be wrong but i thought the auto shafts were a bit shorter due to the tranny being longer. just a thought.

 

[Zumtizzle]

1. A JZ Bell will not bolt onto a M Motor.

2. That is an auto drive shaft.

 

[92TealSupra]

Ahh, alright that's a bummer there for me, I always thought the piece that goes into the transmission would never fit.. so darn..