Search results

thats pretty sweet, what kind of power do you think it will make?

I"m curious which turbo you guys think would be the most responsive and have better spool, a 60 trim with .82 ar or a 67 trim with a .70 ar? I'm trying to decide on which dm kit to get and need help picking which turbo and hotside to go with. Thanks in advance.

ok that helps, i usually just go to qt or race trac but i'll start using those now. Thanks everybody for your help on this issue.

which should i avoid? i remember i had to get gas at a out of town station recently so that was probably it.

i think i had bad gas or something, filled up today and drove around for a bit and the problem got better and better and slowly went away.. wot with -5% taken out afr's are low 11's to high 10s

no its not hooked up.

yes i do see that its lean but any fuel that i add seems to make it cut out.

it definately could be now that i can't even run at stock fuel without it cutting out. Have to run it at -5 percent for it not to cut out. I have a walbro in my wrx that i might take out today and put it and see what it does.

ok here is the first vid with safc on all stock settings. View My Video I did a pull w/ -5% fuel taken out. It did not cut out once. anything over -5% taken out it cuts out bad. I tried +5% and it was even worse. I used to be able to run +10% all the time with no problems.

ok so i picked up a borg warner turbo i knew nothing about for really cheap brand new. After calling borg warner multiple times i was about to get some info. Its a 54 trim turbo with a 1.09 ar hotside and they said it flows 45lbs per minute. I'm going to be going single turbo soon on my 1jz and...

i will try to do that today.

no i haven't yet. Well while driving to work this morning did a couple pulls and problem is still there, its just not as bad. but still cuts out.

well i fixed alot of the problem today. still not sure on exactly the cause. rewired my safc and made sure all connections were good. the wastegate to turbo vacuum hose on one of the turbos i realized was smaller than the one i had on it before, so i changed that to a bigger hose. after i...

check for vacuum leaks, and check the map sensor hose.

i swapped ecu's with an auto 1jz which i was told are the same but my car would barely idle. Makes me think my ecu could be modded or reflashed when i got it. The swap came with a 3inch downpipe and intake and it looked like it had previously had a piggyback wired in. I think i might have...

i'll think about it some and let you know. thanks alot! i dont know if i need those or bigger ones.

yes going to try ecu tomorrow. thanks again for the help.

it would help out some yes. you have some?

couple other things i noticed is that it only happens after 4500 and only when you wide open. If you go 75% throttle to redline it runs just fine, only wide open.

i was thinking of running a 50/50 mix with denatured alcohol and distilled water and just tune it slightly leaner than normal and i was wondering what kind of gains i could see doing so