Search results

Fitment expectations for... Front - 18x9 +37mm offset Rear - 18x10 +40mm offset Tire size suggestions for a 'conservative' fit. Thanks!

My BC 264 cams have been degreed and cam timing currently set at 0. Idle is smooth.

Ryan, FYI - Clint has a 7M housing from his 1JZ swap... Now no more missing 2nd!

It may be wise to consider replacing your bearings after a BHG.

I have seen a charcoal canister from a '94 Accord, and it's not much smaller than the Supras... are you aware of a specific model/year?

Due to my current turbo setup, I have had to removed my charcoal canister due to clearence issues. Does anyone know of a small (smaller the better) canister that can be neatly tucked away somewhere on the intake side of the engine bay?

Thanks man!

I've been ready for a wheel change for awhile now, and have found a set I like. The front size/offset will fit fine (18x8 +37), but I'm not too sure about the rears. They only offer a 18x10 in a +40mm offset. By referencing the oem sawblades (+37mm) and using a wheel fitment calculator, this...

The silicone lines held up just fine. However, over the years I have noticed they don't like worm clamps or battery acid...

Exactly what I needed. Thanks!

Thanks for the link. I remember years ago when I took my car to HoseTechniques to get that kit mocked up... yep, that's my car in the advertisment.

I need to buy some lenghts of vac. hose for my 7M. I think three different diameters of vacuum hose are used on this motor. Can anyone tell me what are the sizes (ID)? Thanks, Jason - Red '88T

Good lookin' supra with low miles! Jason

T04R DBB (66.5mm inducer / .70 a/r) RPS tubular header T'netics Racegate Brand new setup.

I have been running Tokico IlluminaII's with Tokico springs without any issues for well over 5 years or approx. 20K miles. For the type of driving I do, I can't complain.

Currently I can't get to my supra to measure it myself, so hopefully someone can provide close dimensions of the oem oil cooler. I want to order a new cooler today and want to get something that will easily fit in the oem location. Thanks for any help!

Would you happen to have a Blitz Nur Spec catback? They are about an inch shorter...I think they were fabbed for a 1J???

I'm making my own oil & coolant lines, and need to know the thread size for the coolant feed. I have removed the oem feed off the water neck and want to replace it with a fitting that will fit my 6am lines. Thanks for any help. Jason - Red '88T

Jason - Mesa, AZ Red '88 Turbo 5spd with mods.

I'm looking to buy a fitting for my coolant supply line to my T04R DBB turbo. What is the required thread size and pitch needed to fit on the thermostat housing for the turbo coolant supply? I think it's a M12x1.25 (or x1.5?) to -6an (using 6an coolant lines for turbo). Can anyone confirm...