Search results

Finished roughing out the other side earlier.Have to go tomorrow and pick up some sandpaper and primer.Hope to have it all sprayed by Sunday night.Here are a couple more pics. Pass side all measured out. After cutting and bending. Still have to weld some bracing underneath as it's...

Get the supra back together,been WAY too long.

Haha,good stuff.

Fucking Santa clause tried to steal your car.Man whoda thunk it.

This is kinda what I was thinking.

I believe the tsrm has a section in it on what orientation of the tab dictates the shock damping.Either under tems r & r or in the suspension section.

The tems shocks have a tab in the center of the shaft(top shock bolt)my tems shocks came with these little plastic pieces that slipped on top of the shock for non-tems cars and held the tab in the correct orientation for the setting you chose.And no it doesn't affect ride height.

When in doubt,use duct tape.:sarcasm::biglaugh:

Maybe a modified tailgate handle relocater for a pickup truck(flips the handle inside the gate)have the handle back behind the bumper and just a couple tabs on the hood and corresponding ones on the core support w/a rod that slides through them.

I had a '93 bonneville that was incredible in the snow,but my prelude and accord sucked bad.My mk3's didn't do all that well,but being lowered didn't help.Every mk2 I had did great,as do my old cressidas(except on the red & white one when I got lazy and left my 18's on.Wide,35 series tires don't...

It's all in good fun ;).I have owned 53 vehicles since I started driving,16 years ago.IMO there are a lot of other factors that affect seasonal driveability.I have had several FWD cars that just plain sucked in the snow,even w/snow tires,but same goes for some of the RWD cars.Personally,between...

+1^^, that is a sweet looking wheel.

Fixed for ya.:biglaugh:

Sure,I will do it later.I just went and kicked the heat up in the garage so I can go out and work on it.Only took pic of that side 'cause I haven't done the other side yet.Got the other side all measured out though.I will take some pics of the bottom when I get that done also.

I will do that.Thanks.

Correct,that sensor should be in the top of the dash in the far right of the defroster vent,supposed to have a plastic piece and cover that clips into.And yes,the heater core leaking will cause your radiator to empty itself,wouldn't drive 'til you get that fixed.

Thank you.I have done metal work for quite some time,but just recently learned to weld good(instead of blowing holes in the metal).Opened a whole new world of possibilities for custom work.

Basically.The "flaps",or sides of the openings are part of the hood itself.The openings were trapezoid shaped before bending,then took a piece of thin angle iron and clamped it underneath between the skin and frame to use as a kind of dolly to bend the metal and leave a nice radius,then just...

Thanks,and believe me I can't wait to get this whole car back together.Been kinda slacking cause I've been just gathering all the little odd and end parts I needed.

Cool,those worked.Still not a real bad color,for purple.Man I would love to paint some of the cars on here,so many diamonds in the rough.